FasTrac V/O Mortar MSDS

Curing
Direct sun or wind may cause unwanted rapid surface drying. Curing may be accomplished by continuous water fogging for 48 hours or cover with damp burlap or burlene curing blankets. Do not use solvent-based curing compounds. If a coating or sealer will be applied use water fogging or blanket curing methods and prep finished surface per manufacturer’s recommendations.

Clean Up

Clean tools and equipment with clean water immediately after use. Cured material must be removed mechanically.

Limitations

  • Apply only when the surface and ambient temperature are 45-50°F (7-10°C) and rising. See Cold Weather Application guidelines, per ACI, for applications in temperatures less than 50°F (10°C). Applications made during temperatures greater than 85°F (29°C) should follow Hot Weather Application guidelines, per ACI.
  • The minimum required thickness is ¼ inch (6mm).
  • Application depths greater than 2 inches (51mm) must be completed in lifts.
  • Do not add more water than specified.
  • Do not add additional powder from other units
  • Do not over mix


Safety Precautions

Use adequate ventilation. Use of a NIOSH/MS approved dust respirator safety goggles and protective gloves are recommended.

First Aid
In case of eye contact, flush thoroughly with water for at least 15 minutes, and Seek medical attention. In case of skin contact, wash affected areas with soap and water. If the irritation persists seek medical attention. Remove and wash contaminated clothing. If inhalation causes physical discomfort, remove to fresh air. If the discomfort persists, breathing difficulty occurs, or if swallowed seek medical attention. Refer to Material Safety Data Sheet (MSDS) for further information.

Limited Warranty Notice
Every reasonable effort is made to apply exacting standards both in the manufacture of “FasTrac V/O Mortar” product and in the information, which we issue concerning these products and their use. We warrant our products to be good quality and will replace or, at our election, refund the purchase price of any products proved defective. Satisfactory results depend not only on quality products, but also upon many factors beyond our control. Therefore, except for such replacement or refund, Western Material and Design, LLC makes no warranty or guarantee, express or implied, including warranties of fitness for a particular purpose or merchantability, respecting its products, and Western Material and Design, LLC shall have no other liability with respect thereto. Any claim regarding product defect must be received in writing within one year from the date of shipment. No claim will be considered without such written notice or after the specified time interval. User shall determine the suitability of the products for the intended use and assume all risks and liability in connection therewith. Any authorized change in the printed recommendations concerning the use of our products must bear the signature of the Western Material and Design, LLC technical manager.

Go To:
FasTrac V/O Mortar
Tech Data