FasTrac ReSurfacer MSDS

Health and Safety
Make certain the most current versions of product data sheet and MSDS are being used
Risks

Product contains Portland cement and sand (crystalline silica); it can cause skin and eye irritation. Ingestion or inhalation of dust may cause tract irritation. This contains free respirable quartz, which has been listed as a suspected human carcinogen by NTP and IARC. Repeated or prolonged overexposure to free respirable quartz may cause silicosis or other serious and delayed lung injury.

Precautions
KEEP OUT OF THE REACH OF CHILDREN. Prevent contact with skin and eyes. Prevent inhalation of dust. DO NOT take internally. Use only with adequate ventilation. Use impervious gloves, eye protection and if the TLV is exceeded or is used in a poorly ventilated area, use NIOSH/MSHA approved respiratory protection in accordance with applicable federal, state and local regulations.


First Aid

In case of eye contact, flush thoroughly with water for at least 15 minutes, and seek medical attention. In case of skin contact, wash affected areas with soap and water. If the irritation persists seek medical attention. Remove and wash contaminated clothing. If inhalation causes physical discomfort, remove to fresh air. If the discomfort persists, breathing difficulty occurs, or if swallowed seek medical attention. Refer to Material Safety Data Sheet (MSDS) for further information.

Proposition 65
This product contains material listed by California as known to cause cancer, birth defects, or other reproductive harm.

VOC Content
0 lbs/gal or 0 g/L

Limited Warranty Notice
Every reasonable effort is made to apply exacting standards both in the manufacture of “FasTrac ReSurfacer” product and in the information, which we issue concerning these products and their use. We warrant our products to be good quality and will replace or, at our election, refund the purchase price of any products proved defective. Satisfactory results depend not only on quality products, but also upon many factors beyond our control. Therefore, except for such replacement or refund, Western Material and Design, LLC makes no warranty or guarantee, express or implied, including warranties of fitness for a particular purpose or merchantability, respecting its products, and Western Material and Design, LLC shall have no other liability with respect thereto. Any claim regarding product defect must be received in writing within one year from the date of shipment. No claim will be considered without such written notice or after the specified time interval. User shall determine the suitability of the products for the intended use and assume all risks and liability in connection therewith. Any authorized change in the printed recommendations concerning the use of our products must bear the signature of the Western Material and Design, LLC technical manager

[dywp_button url=”http://www.wmdus.com/fastrac-resurfacer” style=”grey” size=”small” icon=”no-icon” type=”square” target=”_self”] ReSurfacer [/dywp_button][dywp_button url=”http://www.wmdus.com/fastrac-resurfacer-tech-data” style=”grey” size=”small” icon=”no-icon” type=”square” target=”_self”] Tech Data [/dywp_button]
FasTrac ReSurfacer MSDS PDF View or Print

[table id=1 /]

Go To:
FasTrac ReSurfacer
Tech Data